What uncertain factors will be generated by the blow molding machine in the production
What uncertain factors will occur in the production of the blowing machine? When the manufacturer usually produces the flying pigeon blowing machine, the weight of the product produced by the blowing equipment is often unstable, and the weight of the product exceeds the specified deviation, etc. Phenomenon. The characteristic of weight instability is that the length of the nozzle material at the bottom of the bottle is different. In severe cases, the length of the material tube is not enough, so that the product cannot be blown. The temperature control is inaccurate or the temperature deviation is large, and the installation position of the temperature measuring point (thermocouple) is unreasonable, which makes the temperature produce periodic deviation. As the temperature deviation increases, the deviation affecting the weight also increases. When the temperature rises, the stretching of the extrusion barrel increases. In the same operation cycle, the nozzle material at the bottom of the bottle increases, and the weight of the product is reduced. When the temperature is low, the weight of the product increases. When the thermocouple has poor contact, there is a similar failure. If the thermocouple is bad, the extrusion volume will decrease, and when the temperature is lower than the melting point of the plastic, the motor current will increase. It cannot be extruded below the melting point of the plastic. Whether the installation position of the thermocouple is reasonable and the size of the temperature control area of u200bu200bthe thermocouple measuring point will directly affect the extrusion stability. 2. The running time of the two mold bases is inconsistent (the difference is too large). If the downward flow of the material pipe is at a constant speed, when the time difference between the left and right mold bases is large, the weight of both sides will be unstable. The mold base that runs faster is heavier, and the mold base that runs slower is lighter due to stretching. The solution is to adjust the die set on both sides to make the run time close. 3. The extrusion volume is unstable, and the extrusion volume is unstable due to the unstable rotation speed of the motor and the unsuitable lightness of the belt. 4. The reason for the plastic raw materials is that the output is different due to the change of different plastic raw materials or the mixing ratio. The amount (percent) of the nozzle material added often affects the extrusion volume.
Yosion Machinery is one of the world’s leading and most-trusted suppliers to the relevant markets.
Get blowing machine maker bottle blowing machine from only reliable exporters, go to Yosion Machinery for more details.
While plastic bottle machine, yosion bottle blowing machine bottle blowing machine can help achieve high accuracy._x000D_
To offer abundant options of product is an important factor to a company, such as bottle blowing machinepet bottle making machine manufacturers to afford high-quality products for customers.
bottle making machine bottle blowing machine will help keep your blwoing machine company in a pet bottle manufacturing machine state.