Do not panic when the automatic blow molding machine fails
Common problems of automatic bottle blowing machine 1. Automatic bottle blowing machine feeding old card feeding tray: This situation is a headache. From experience, if the length of the preform (preform) is longer, the cutting weight will be larger. If there is such a possibility, this phenomenon is relatively rare. 2. No feeding at the feeding level: There are several situations to check: 1) Whether the hopper has run out of material, if so: need to feed quickly; 2), if not: please check whether the control contactor of the hoist is in the power-on state . If it is powered on, quickly check whether the motor is powered on and loaded, because in this case it is likely that the preform (preform) is stuck on the feeding belt of the feeding machine. The easiest way at this time is to help manually. Lift; 3) If the control contactor of the check feeder is not in the power-on state, please check whether the preform detection electric eye and the reflector are not in the same line. 3. Whether the position of the bottle is always pinched by the manipulator is misplaced. 4. The bottle cannot be taken out of the mold after blowing. First, the mold should be opened, and the mold should be opened and closed manually. If it is normal, run it in the dry running state, if it is normal. Check the exhaust time setting. If the exhaust setting is normal and the fault occurs every time the bottle is blown, then it can be judged that it is the problem of the exhaust valve. Please open the exhaust valve to check its spring and seals (this kind of failure also There is a phenomenon that the exhaust sound is relatively loud or there is an unclean sound). If the mold cannot be opened by chance due to the normal production of many molds, please check whether the clamping pin has a segmented screw in it, and also check whether the clamping force is too large. If it is too large, it should be readjusted according to the standard. 5. The two manipulators of the automatic blow molding machine collided or collided with other things: in this case, it is necessary to manually reset the manipulator and check the parameters. 6. Drop the bottle when out of the bottle. The reason is that the bottle opening finger automatically opens or the bottle mouth cannot be clamped, and the nylon block inside the finger needs to be replaced. 7. When the mold is opened, the accompanying fixture leaves the bracket. The reason is that the bracket deviates from the center of the mold, and the torsion of the mold seat collides with the fixture, so just adjust the position of the bracket. We will provide customers with timely, professional and efficient after-sales service, including bottle blowing machine introduction, installation, commissioning, maintenance, technical training, on-site service, regular follow-up visits, etc. When the machine fails, we will assist the customer by telephone or network and provide solutions within a short period of time, and promptly arrange for technicians to come to repair if necessary.
are important in ensuring pet bottle making machine manufacturers, and the machine is utilised by everyone from bottle making machine to yosion bottle blowing machine.
Want to learn more about plastic blowing machine manufacturers bottle blowing machine? Check out Yosion Machinery.
Yosion Machinery is an expert in manufacturing a wide range of . We also have high quality pet bottle manufacturing machine and many others. Visit to know more.
We are professional in manufacturing bottle blowing machine, and always emphasize the technology and quality during the producing procedure.
Offering a loyalty program not only makes customers feel valued, but it allows Yosion Machinery to easily collect important information about customers.