What uncertain factors will be generated by the blow molding machine in the production1
What uncertain factors will occur in the production of the blow molding machine? Usually, when the automatic blow molding machine is produced, the weight of the product is often unstable, and the weight of the product exceeds the specified deviation. The characteristic of weight instability is that the length of the nozzle material at the bottom of the bottle is different. In severe cases, the length of the material tube is not enough, so that the product cannot be blown. The temperature control is inaccurate or the temperature deviation is large, and the installation position of the temperature measuring point (thermocouple) is unreasonable, which makes the temperature produce periodic deviation. As the temperature deviation increases, the deviation affecting the weight also increases. When the temperature rises, the stretching of the extrusion barrel increases, and in the same operation cycle, the nozzle material at the bottom of the bottle increases, and the weight of the product is reduced. When the temperature is low, the weight of the product increases. When the thermocouple has poor contact, there is a similar failure. If the thermocouple is bad, the extrusion volume will decrease, and when the temperature is lower than the melting point of the plastic, the motor current will increase. It cannot be extruded below the melting point of the plastic. Whether the installation position of the thermocouple is reasonable and the size of the temperature control area of the thermocouple measuring point will directly affect the extrusion stability. 2. The running time of the two mold bases is inconsistent (the difference is too large). If the downward flow of the material pipe is at a constant speed, when the time difference between the left and right mold bases is large, the weight of both sides will be unstable. The mold base that runs faster is heavier, and the mold base that runs slower is lighter due to stretching. The solution is to adjust the die set on both sides to make the run time close. 3. The extrusion volume is unstable, and the extrusion volume is unstable due to the unstable rotation speed of the motor and the unsuitable lightness of the belt. 4. The reason for the plastic raw materials is that the output is different due to the change of different plastic raw materials or the mixing ratio. The amount (percentage) of the added nozzle material often changes and affects the extrusion volume. Zhangjiagang City Co., Ltd. specializes in research and development and production of various Specifications of the blow molding machine manufacturers.
The average consumer is always looking for ways to save money while finding out solutions, is designed for killing two birds with one stone, providing a perfect solution to bottle blowing machine problems.
Exceed customers' expectations in the procedures of manufacturing bottle blowing machine.
There are multiple advantages of having a pet bottle making machine manufacturers bottle blowing machine from responsible drilling machine exporters such as Yosion Machinery, as they adhere to all the quality standards as you can list and supply all plastic bottle machine essential for the operation of the device without any difficulty.