What are the common technical problems of PET blow molding machine?

The blow molding process is a two-way stretching process, in which the PET chains are extended, oriented and aligned in both directions, thereby increasing the mechanical properties of the bottle wall, improving the tensile, tensile, and impact strength, and having a very high performance. Good air tightness. Although stretching helps to improve the strength, it should not be overstretched, and the stretch-inflation ratio should be well controlled; the radial direction should not exceed 3.5-4.2, and the axial direction should not exceed 2.8-3.1. The wall thickness of the preform should not exceed 4.5mm. The blowing machine is carried out between the glass transition temperature and the crystallization temperature, generally controlled between 90-120 degrees. In this range, PET exhibits high elasticity and rapid blow molding, and becomes a transparent bottle after cooling and setting. In the one-step method, this temperature is determined by the length of the cooling time during the injection molding process, so it is necessary to connect the injection molding machine well.—Blow the relationship between the two stations. In the blow molding process: stretching—blow once—In the second blow, the time of the three actions is very short, but they must be well coordinated, especially the first two steps determine the overall distribution of the material and the quality of the blow molding machine. Therefore, it is necessary to adjust well; stretching start timing, stretching speed, pre-blowing start and end timing, pre-blowing pressure, pre-blowing flow, etc. If possible, it is best to control the overall temperature distribution of the preform and the inner and outer walls of the preform. Temperature gradient. There are common problems and solutions for induced stress in the bottle wall during rapid blow molding and cooling. 1. Thick on the top and thin on the bottom: delay the pre-blowing time or reduce the pre-blowing pressure to reduce the air flow. 2. Thicker at the bottom and thinner at the top: the opposite of the above. 3. There are wrinkles under the bottle neck: the pre-blowing is too late or the pre-blowing pressure is too low, or the blank is not cooled well here. 4. White bottom: the preform is too cold, overstretched, pre-blowing is too early or pre-blowing pressure is too high. 5. There is a magnifying glass phenomenon at the bottom of the bottle: too much material at the bottom of the bottle, pre-blowing is too late, and pre-blowing pressure is too low. 6. There are wrinkles in the bottom of the bottle: the temperature at the bottom is too high, the cooling at the gate is not good, the pre-blowing is too late, the pre-blowing pressure is too low, and the flow rate is too small. 7. The entire bottle is cloudy: opaque, not cooling enough. 8. Partial whitish: Excessive stretching, the temperature here is too low, or pre-blowing is too early, or the stretching rod is touched. 9. Bottom eccentricity: It may be related to the temperature of the preform, stretching, pre-blowing, high-pressure blowing, etc. Reduce the temperature of the preform, speed up the stretching speed, check the gap between the tie rod head and the bottom mold, delay the pre-blowing, reduce the pre-blowing pressure, delay the high-pressure blowing, and check whether the preform is eccentric. The company mainly produces automatic blow molding machines
Looking for a producer to fix your bottle blowing machine problems? Then contact the bottle blowing machine experts at Yosion Machinery, offering a wide range of products across the global market. Visit Yosion Machinery to find our best offer!
For more information please see our site at Yosion Machinery. Don't be hesitate to contact us!
Further dialogue of Yosion Machinery between the approaches, the chapter concludes, could lead to actionable advice on more robust policies that drive both structural change and competitiveness upgrading.
comes in a vast array of styles and bottle making machine depending on which blwoing machine companyis used.
Many of the bottle blowing machine listed here can be purchased for less money, but in general we recommend paying a slightly higher price for significantly improved performance. These are our top choices and their recommended configurations.