Teach you a few action of bottle blowing machine maintenance and repair

1 charging not charging: need to check several ways: whether there had been no material hopper, if is: need to charging not: please check whether the elevator control contactor in electrical state, if it is to state, to check whether the motor is in power and load state, because this kind of situation is likely to be the bottle preform ( Embryo) Stuck with ascension, then a simple method is to promote human help. If you examine elevator control contactor is not to state, please check whether the bottle embryo detect magic eye with reflector plate is not on the same line. 2 feed themselves feed table: this kind of circumstance is a headache problem, empirically if the bottle preform ( Embryo) The length of the longer cut weight is bigger, then this kind of phenomenon is relatively less. After 3 bottle blowing into cannot be removed from the mold. Should open the mould first, with a manual process, if the normal, with empty running state run it, if is normal. Please check your exhaust time Settings, if the exhaust set to normal, and every time as long as a bottle blowing failure, then can judge is the problem of exhaust valve, please open the exhaust valve check its spring and seal ( This kind of failure is also a phenomenon is the exhaust noise is larger or have not the voice of the net) 。 If you meet a lot of mold production normal chance to check on the open mold, please check the lock pin if there is a section of the screw inside, please check whether the clamping force is too big, if too big should be readjusted according to the standard. 4 bottles is a task of the position of the manipulator is misplaced.